Current and Voltage Transducer
The new current or voltage measuring transducers include a Rogowski coil that can be opened to allow the user to retrofit the modules in an existing system without interrupting the circuit. Three measuring ranges are available at the input and can be selected with a switch. For each voltage module, an output of 0-5V or 0-10V signal can be easily selected. Sinusoidal and non-sinusoidal AC currents of 30 to 6000Hz to a maximum current of 400A can be measured.
The clamp-on cable design allows the modules to be retrofitted at any time with ease and without interrupting the circuit. Just open up the sensor, fit the module around the conductor, and close the sensor – Done!
The sensor can be opend for installation in existing systems without disconnecting the circuit!
Features
Three measuring ranges with just one transducer by simply switching the range switch
- Rogowski coil, can be “opened-up”
- With the COMBICON connector, it makes it easier to connect the modules
- Three measuring ranges with just one transducer by simply switching the range switch
- Low height of 67mm allows the user to install in flat distributor boxes
- With a conductor diameter of up to 18.5mm on the input side can be clamped
- Great variety of applications due to 2 versions (current or voltage output)
- DIN rail mountable or direct screw connection
- cUL Listed
- cUL Class 1 Div 2 submitted. Anticipated completion: April 2007